batteries - Uma visão geral
batteries - Uma visão geral
Blog Article
The active material on the battery plates changes chemical composition on each charge and discharge cycle; active material may be lost due to physical changes of volume, further limiting the number of times the battery can be recharged.
Secondary (rechargeable) batteries can be discharged and recharged multiple times using an applied electric current; the original composition of the electrodes can be restored by reverse current. Examples include the lead–acid batteries used in vehicles and lithium-ion batteries used for portable electronics such as laptops and mobile phones.
Batteries are represented in electrical schematics and diagrams by using a simple symbol. The symbol may differ depending on the type of battery used.
The second way they can be used is in the same way as a primary battery, the difference is that can be charged once the battery has lost its charge. Normally this will involve connecting the battery to a certain power source, such as mains electricity to charge the battery for a short time. An example of this is a laptop, when the battery is running low you simply connected it to the mains to charge again.
Zinc-air batteries typically operate by oxidizing zinc with oxygen from the air. Since they are activated by air, they are ready for use when the oxygen interacts with the zinc in the battery. They have high energy density and are relatively inexpensive to produce.
In the 2000s, developments include batteries with embedded electronics such as USBCELL, which allows charging an AA battery through a USB connector, nanoball batteries that allow for a discharge rate about 100x greater than current batteries, and smart battery packs with state-of-charge monitors and battery protection circuits that prevent damage on over-discharge. Low self-discharge (LSD) allows secondary cells to be charged prior to shipping.
Benjamin Franklin first used the term "battery" in 1749 when he was doing experiments with electricity using a set of linked Leyden jar capacitors. [4] Franklin grouped a number of the jars into what he described as a "battery", using the military term for weapons functioning together.
Given that the price of lithium increased at a higher rate than the price of nickel and cobalt, the price of LFP batteries increased more than the price of NMC batteries. Nonetheless, LFP batteries remain less expensive than NCA and NMC per unit of energy capacity.
The VRLA battery uses an immobilized sulfuric acid electrolyte, reducing the chance of leakage and extending shelf life.[38] VRLA batteries immobilize the electrolyte. The two types are:
The casing of batteries is made from steel, and the rest of the battery is made from a combination of materials (listed above) dependent on type акумулатори бургас and application. The rest of the cell is made from a combination of paper and plastic.
It is a type of lead-acid battery in which the sulfuric acid electrolyte is condensed (thickened), so it cannot drain out. They are somewhat sealed but have vents if the gases are accidentally released by overcharging. This battery is designed to last up to 12 years.
The electrolyte is a solution that allows electrons to flow between the electrodes and the terminals.
Disposable batteries typically lose oito–20% of their original charge per year when stored at room temperature (20–30 °C).[57] This is known as the "self-discharge" rate, and is due to non-current-producing "side" chemical reactions that occur within the cell even when no load is applied. The rate of side reactions is reduced for batteries stored at lower temperatures, although some can be damaged by freezing and storing in a fridge will not meaningfully prolong shelf life and risks damaging condensation.
Sodium-Metal Halide: Also known as ZEBRA batteries, these hold potential as stationary batteries used to store energy for the grid. PNNL researchers have developed a design that is more stable and less expensive to manufacture, with increased energy density.